Actions

Difference between revisions of "M3D Micro"

From HacDC Wiki

(WIP)
(WIP)
Line 21: Line 21:
* The "Linux" version is merely a Micro$oft Windoze .NET image that needs mono to run
* The "Linux" version is merely a Micro$oft Windoze .NET image that needs mono to run
* [http://printm3d.com/files/software/linux/README-1.5.0.70.pdf Documentation]
* [http://printm3d.com/files/software/linux/README-1.5.0.70.pdf Documentation]
On Arch Linux, after adding myself to group '''uucp''' and installing '''mono''':
    mono ./M3D.App/M3DGUI 1>/dev/null 2>&1 &
installed new firmware, and then wanted to do a 30-minute calibration... Some other time. I'm hungry.

Revision as of 18:00, 28 May 2018


Andrew Barabasz donated a M3D Micro+ or, more probably an older Micro (2018.05.27).

Included

  • M3D Switching Adaptor
    • Output 5.0 V, 4.0 A
    • Negative ring, positive tip
  Positive Tip Plug.svg
   _____
   -----


Software

On Arch Linux, after adding myself to group uucp and installing mono:

   mono ./M3D.App/M3DGUI 1>/dev/null 2>&1 &

installed new firmware, and then wanted to do a 30-minute calibration... Some other time. I'm hungry.